Recent content by Zackw
-
-
-
-
-
-
Tikka 300 WSM magazine options for extra COAL
It’s been a while since I modified that magazine, so I don’t specifically remember. Looking at it now I’m guessing that I either scored it repeatedly in the corner with a knife until it came out, or I might’ve used some kind of wire cutters or snips to cut out the plastic plate. Then I probably... -
300 WSM load recommendation
My go-to load is 175gr lrx’s over 64.5gr IMR4350 in Hornady brass. Going 2960fps out of a 24” Tikka t3x. Consistent 3/4” groups. -
.223 75gr eldm varget
I was trying to work up a load with that combo. Settled on 25.0gr varget at 1.905” cbto. Getting 2910fps in a 22” tikka. Accuracy never came close to berger 80gr vld’s so I gave up. -
-
-
-
-
Tikka 300 WSM magazine options for extra COAL
This was my solution. I pulled the factory wsm magazine apart, cut out the rear wall with a dremel, smoothed it down as best I could, inserted and epoxied a piece of plastic, and then reassembled. The follower has some float, but it hasn’t affected feeding. It will now fit oal up to 3.100” with... -
-
Featured Video
Stats
Latest Articles
-
TT#28 Idaho Bear Hunting with Roger Holscher and Chris Young
-
Rockstar Research with Kevin Monteith
-
Hunting Big Mule Deer: Obey the Wind & Still-Hunting
-
TT#27 DIY New Zealand Hunting with Australian Duo Miller and Pitts
-
Fewer Bucks, More Fawns?
-
Mathews Lift Review
-
Wyoming Range Winter Wrap-Up with Jeff Short
-
The Pursuit with Cliff Gray
-
Mile High Mule Deer Seminar
-
TT#26 Kyle Virgin and the infamous Hobbit Rifle