It went very smoothly, I used a hacksaw with fine teeth to really control it after taping and marking my lines. After removing the inch I pulled out the existing butt plate and used a Dremel to resize to fit. Then epoxied that in with some jb weld. I contemplated reusing the butt pad but went...
I've had very good results using the hornady superperformance GMX and now CX. A bit cheaper than Barnes factory ammo and very similar results. Never have recovered a bullet yet.
I have a 2020 3.0 Silverado rst. It has been trouble free until last month. The timing chain went. I have 110k on it, just out of warranty but GM is splitting the cost of repairs with me. Beyond that I love the truck, great mileage, great towing, very comfortable.
I know this is old but do you happen to have a picture of the scope/base/ring combo on your Sauer 100? I have the same rifle and ended up going with a warne rail and vortex pros to mount the accu point. Thank you.