If you go back and read the multitude of comments in this thread it becomes clear that there are a number of complaints. This was my primary concern, if support after the sale is non existant than this diminishes the worth of the item for me.
I am truly happy for you that your gear works as it...
Harvey_NW,
I think we are saying the same thing. The reamer and go/no go guages are ground based on the SAAMI drawing with exceptions to custom modifications IE: the AW II reamer, and others.
I agree that a re-sharpened reamer could certainly cut an undersize chamber, the fact that the chamber...
SAAMI accepted and published reamer and chamber drawings for 300 PRC & 6.5 PRC, June 13, 2018 with zero Revisions. If Fierce were chambering to the stated SAAMI prints, an ammunition mismatch would be unlikely as these issues would have already been considered prior to SAAMI publication.
Dull...
I forgot to mention the absurdity in paying or even offering a Machinist $17.00 an hour. Perhaps Fierce is manning their shop with vo-tech students in their first machining job.
I'm so thankful I ran into this thread!!!!!!!!!!!!! I had decided that Fierce was the cream of the crop among semi customs.
To all the Members who have good running Fierce rifles I am genuinely happy for you.
I place a tremendous value on integrity and accountability. This thread has given...
Wayne eventually built his retirement by selling out the core values of the Membership. Typical Northern Virginia political shell game....Nothing to see here.
Lapua, Winchester, Norma in that order.
Norma is very good but soft. If you load hot the primer pockets will open up. Same loads in Lapua brass give me 6 or 7 firings to only 3 firings in Norma. Winchester is good hard brass but you gotta weigh them and seperate in groups.
Based on the feathers ruffled....perhaps "OP" = Original Prankster.
Just kidding guys, relax ,take a deep breath and let your hair down. Dawwwwwpp, I did it again. STOP