Excellent condition Foundation Exodus (RH, SA) for Impact Precision action. Has full set of brass weights, KMW bottom metal and full length arca rail. Weighs around 6.6lbs.
$1000 shipped
Anyone out there with a long action PH willing to share a pic of the arca rail?
Still wondering about the placement in regard to the magwell. (An earlier post in the thread said it was mounted a good bit farther forward compared to the SA stocks)
This was helpful info. I’m starting my build and I think I’ll go 22” to be run with a TBAC Ultra 7. Planning on 162gr ELDX factory stuff and don’t wanna risk dropping below 2700fps with a 20” barrel.
Having a hard time choosing a stock at the moment.
Area419 20 MOA pic rail (with screws and the recoil pin) and a 5-round Tikka factory mag for 6.5 Creedmoor.
Both are in excellent condition.
$110 shipped
(Rifle is already sold)
I picked this up recently with the intention of having a 48cm BDC turret installed. Sent it to S&B for installation only to find out the most I could get would be the 32cm which isn’t enough for my uses so I had them send it back to me and now it’s for sale. Slight ring marks.
30mm tube, A7...
Pretty frustrating to NOT see a 7PRC nor 6CM option after a dozen or more other manufacturers have had them
available for months. Been holding out before rebarreling my T3x or just selling it and going with a custom action. I love the 60 degree bolt, the trigger, and I even like the stock just...