These are NEW never mounted. I ordered them let them set around until I had time to mount them. ...well 2 weeks turned into 10 or so then I discovered they had sent the wrong rings... too late to return them. My loss your gain.
Talley #74x719 30mm, Medium height, extended front, 8-40 fit...
I have 147 (total count) Nos 30 cal 210gr ABLR bullets. These were purchased as 1st run bullets, I do not consider them as 1st run. They may been stored for a long time before I purchased them as some have a small bit of corrosion on the tip at the plastic, see the photo as I tried the find the...
I carry chains (4) also a come-along, chain, 4 inch nylon strap,..
I also have this RULE:
I do not use chains to get into a place. I only use them to get out of a place.
I gotcha, seeing max data for the same components change over time is not reassuring. Makes me wonder did they get it wrong before? (what else did they get wrong), did lawyers get involved, surely the powder didn't change. I, like you work it up and check for pressure signs... especially as...
Since the Barnes bullets (TSX, TTSX,...) are solid copper (or solid copper alloy) and not a copper jacket over a lead core, they don't deform in the rifling as easy and pressures may be higher. I would tend to follow Barnes for Barnes bullets. As always... start low and work up.
I hoping someone has tackled this issued. I looking for ideals to make my own clamp on spotting scope holder for a shooting bench when I go to the range. I seen some nice ones but they acquire lathe work which I don't have.
When I say clamp I'm thinking a clamp that wood workers use to glue...
Thanks for writing that up and sharing. I've wonder about how those hunts are actually conducted. But being a non-Res to CO, I haven't actually looked into it much.